TL rotary tiller is a kind of tillage machine that is matched with tractor to complete tillage and harrowing operations. It can be divided into horizontal axis type, vertical axis type and inclined type according to the configuration mode of tl rotary tiller blade axis. The rotary cultivator is widely used because of its strong soil breaking ability and flat surface after tillage. However, in the specific operation process, the rotary cultivator should be used and maintained correctly, otherwise, it will not only affect the farming quality, reduce the service life of the machinery, but also pose a threat to its own safety.

How to use the tl rotary tiller:

Starting: The tl rotary tiller shall be powered under the lifting state. The unit can only start after the tl rotary tiller reaches the predetermined speed. It is better to run slowly at a low speed, which can not only ensure the operation quality, fine pieces of soil, but also reduce the wear of the machine parts. At the same time, pay attention to listen to whether the tl rotary tiller has noise or metal knock, observe the soil breaking and ploughing depth. If there is any abnormality, turn off the engine immediately to ensure personal safety, and then carry out the inspection work. Continue to work after troubleshooting.

Turning: It is forbidden to work when turning on the mechanical land. The tl rotary tiller should be raised to make the blade leave the ground. At the same time, the accelerator of the tractor should be reduced to avoid damaging the blade. The tail wheel and steering clutch shall cooperate with each other and proceed slowly. Sharp turning is prohibited to prevent damage to relevant parts. When lifting the rotary cultivator, the tilt angle of the universal joint shall be less than 30 degrees. If the angle is too large, impact noise will be generated, causing premature wear or damage.

Reverse and transfer: When reversing, crossing ridges and transferring land, lift the tl rotary tiller to the highest position and cut off the power to avoid damage to the machine parts. If it is to be transferred to a distance, the tl rotary tiller shall be fixed with a locking device.

The above are some introductions on how to use the tl rotary tiller. Zanuo is a rotary tiller manufacturer from china, and our rotary tillers are designed by professional engineers according to European and American safety standards. At the same time, we have experienced staff and advanced equipment to ensure high quality. If necessary, welcome to consult!