Rotary tiller is a kind of tillage machine which is used with tractors to complete tillage and harrowing operations. It is widely used because of its strong soil breaking ability and flat surface after tillage. The correct use and adjustment of rotary tiller is very important to maintain its good technical condition and ensure the quality of cultivation. The following focuses on how to operate the rotary tiller correctly.

We can operate the rotary tiller according to the following steps:

At the beginning of the operation, the rotary tiller shall be in the lifting state. First, combine the power output shaft to increase the speed of the knife shaft to the rated speed, and then lower the rotary tiller to make the blade gradually penetrate the soil to the required depth. It is forbidden to combine the power output shaft or drop the rotary tiller sharply after the blade is buried in the soil, so as to avoid bending or breaking the blade and increasing the load of the tractor.

During the operation, it is required to drive slowly at a low speed as far as possible, which can not only ensure the operation quality, make the soil block finely broken, but also reduce the wear of the machine parts. Pay attention to whether the rotary tiller has noise or metal knock, and observe the soil breaking and ploughing depth. In case of any abnormality, stop the machine immediately for inspection, and continue the operation after troubleshooting.

When turning on the headland, it is forbidden to work. The rotary tiller should be raised to make the blade leave the ground, and the tractor accelerator should be reduced to avoid damaging the blade. When lifting the rotary cultivator, the tilt angle of the universal joint shall be less than 30 degrees. If it is too large, it will produce impact noise, causing premature wear or damage.

When backing up, crossing the ridge and transferring the land, the rotary tiller should be lifted to the highest position and the power should be cut off to avoid damage to the machine parts. In case of remote transfer, the rotary tiller shall be fixed with a locking device.

After each shift, the rotary cultivator shall be maintained. Remove the soil and weeds on the blade, check the fastening of each connecting piece, add lubricating oil to each lubricating oil point, and add grease to the universal joint to prevent increased wear.

The above are some introductions on how to operate the rotary cultivator. ZANO is a rotary tiller manufacturer from china, and we have rich experience in producing rotary tillers. Our rotary tillers include light rotary tillers and heavy duty rotary tiller.All our products are designed by professional engineers according to European and American safety standards. If necessary, please come to consult!