The appearance of rotary tiller has greatly improved the efficiency of agricultural production and reduced the work intensity of working farmers. At present, it has been widely used in China. As a large agricultural machine, the failure of the rotary cultivator will lead to the shutdown of the cultivated land. So we need to know about the common failures and troubleshooting methods of the rotary cultivator. Now let the rotary cultivator manufacturer give you a detailed introduction!

If the blade shaft of the rotary cultivator fails to rotate suddenly, the operator should stop the operation immediately, check whether the blade shaft is wrapped with grass or blocked with mud, and if so, clean up weeds and mud in time and adjust the clearance; Then check whether the gear bearing is damaged. If it is seriously damaged, replace it with a new bearing in time. Never "work with problems".

If the machine jumps or shakes because the blade is installed incorrectly, it should be stopped immediately for inspection. If the blade is installed incorrectly, it should be adjusted immediately.

The sudden black smoke and skidding of the rotary tiller are caused by the heavy load of the rotary tiller, which leads to the excessive depth of rotary tillage and the unbearable load of the machine. Usually, this symptom is related to the hard soil, and the forward speed of the unit should be reduced.

When hearing the sound of metal collision and knocking, the operator shall stop the operation, drive the machine away from the operation site, and get off the vehicle for inspection. First, check whether the transmission chain is loose. The loose chain is likely to cause box collision and knocking sound. Adjust the tightness of the chain; Then check whether the blades at both ends of the rotary blade shaft and the left arm or the transmission box are deformed. If there is deformation, there will be a collision sound. You need to fix the screws, correct the deformed parts with a hammer, and tighten the fixing bolts. You can continue to use it after doing these things.

If there is noise in the gear box, stop the machine to check whether the bearing is damaged and whether the gear has teeth falling. If it is caused by the bearing, replace it with a new one

The above is an introduction to the solutions to common faults of rotary tiller. ZANO is a rotary tiller manufacturer. We have many years of experience in producing and selling manufacturer. At present, our rotary tiller is manufactured according to European and American standards. If necessary, please consult us!